Avscash Trust, T/as Cutlist.biz Cabinet Making
ABN: 61 427 657 214
QBSA: 1176277
Address: 27-33 Bunya Crt, Cedar Vale, Qld, 4285
Ph: 07 5543 2949
Fax: 07 5543 2983
Mob: 0422 443 170

Cutlist.biz Cabinet Making. Custom Designed Cabinetry 

Facebook Twitter Gplus YouTube Google Maps E-mail RSS
Home 2008 October
formats

Work in progress

Published on October 29, 2008 by in General

Thought I would post some pics of a job I am currently working on in Paddington. This is a work in progress so the photo’s will show stuff still not 100% complete This is all made with hoop pine rotary cut plywood finished in satin two pac with exposed plywood edges, laminex eggplant and stainless steel tops and splash backs. Everything was architecturally designed. I will post more complete photos once the house is finished.

 
 Share on Facebook Share on Twitter Share on Reddit Share on LinkedIn
  comments 
formats

Leveling up cupboards

Tools required: Level, Chisel, Block of wood and various packers from 1mm thick to 10mm thick First grab your level and lay it across the back edge, take note of which end the bubble floats to. If it is in the middle, between the two lines then the back edge is level, if it has floated to one side, then that is the high point. From the high point, set your level from that corner to the front corner, take note of which end the bubble floats to again. If the bubble is at the same end as your last high point, then this is where you need to start levelling the cupboard from. If the bubble floats to the opposite end to the previous high point, then you need to repeat the process from this new one. Once you have determined exactly which corner is the highest point, you then need

Read More…

 
 Share on Facebook Share on Twitter Share on Reddit Share on LinkedIn
  comments 
formats

Power Safety Tools

I remember when I was an apprentice using an Electric Plane to plane down the side of a vanity benchtop. As an apprentice I was silly enough to be wearing a long shirt that wasn’t tucked into my pants. While I was planing the side down my shirt came to close to the Electric Plane and got dragged into the blades. Lucky for me, it dragged in enough of the shirt to jam up the blades and stopped them from spinning anymore, otherwise I would’ve had a got chunck of my stomach torn out. So this is one of the reasons why I thought some safety tips for power tools would be a good thing to write about. 1. Always tuck in loose clothing and preferably don’t wear lose fitting clothing. 2. If you wear rings on your fingers, remove them whilst using power tools. 3. Wear saftey goggles whenever using tools

Read More…

 
 Share on Facebook Share on Twitter Share on Reddit Share on LinkedIn
  comments